999zip999
100 TW
I hooked up the motor to an em3ev 12fet.@ 80v & 40amps. This is the same controller I used with the em3ev muxus 9c clone I melted at 3200 watts.
It ran fine for 8mi. 3200w. I started up a small hill and it started chugging, Like a loose phase wires or ?
Put the ebike tester on it all tested good, halls, phase, throttle, the controller test showed 2 twin sets of leds one time around then stopped. I did the Jaterureka fet test, as probe for resistance between all controller phases and pos. B&G 10.42k Y 10.38k Then all three and neg. All 10.40k. Is this the problem ?
I then open the motor and pulled some phase wires thru and resolder to check off wires I cut in axle, plus checked halls again. It's good. ???
Plus did the turn the wheel backwards with the controller on, throttle off. No resistance.
My brain hurts.
It ran fine for 8mi. 3200w. I started up a small hill and it started chugging, Like a loose phase wires or ?
Put the ebike tester on it all tested good, halls, phase, throttle, the controller test showed 2 twin sets of leds one time around then stopped. I did the Jaterureka fet test, as probe for resistance between all controller phases and pos. B&G 10.42k Y 10.38k Then all three and neg. All 10.40k. Is this the problem ?
I then open the motor and pulled some phase wires thru and resolder to check off wires I cut in axle, plus checked halls again. It's good. ???
Plus did the turn the wheel backwards with the controller on, throttle off. No resistance.
My brain hurts.