once again i need help!!! programming

[bigsi]

Hi again guys. Right I have a lyen 18x 4115. 18 x 3077, 24 x 4115 and 24 x 4110,

Both 18 controllers program fine. Both 24's don't. I've followed all info. Ie set to 25% on 12 fet settings etc. My programing leads both have the yellow wire bridibg pins one and five. All controllers are mk2.

Any ideas?

Thanks again. Si

 

[davec]

strange- need more details
what error you getting>?
what EB profile?
i also got a question - does anyone know what voltage the programming cable operates for ttl i/o voltage? im talking the rx/tx pins- is it 3.3v or 5?

 

[bigsi]

strange- need more details
what error you getting>?
what EB profile?
i also got a question - does anyone know what voltage the programming cable operates for ttl i/o voltage? im talking the rx/tx pins- is it 3.3v or 5?

They should be 5v
I tried the 12 fet profile then modded it as mine doesn't have 24 fet profile. Paul at em3 said this works... But doesn't haha. No error message either just hangs and doesn't write as if driver doesn't work. However works fine I. The other controllers

Cheers. Si

 

[davec]

actually correction lyen uses a pl2303 (as he supplies drivers for this chip) - unless there's a 5v variation as far as im aware the pl2303 does 3.3volts on the i/o (tx/rx pins) i just programmed my controller with a pl2303hx which uses 3.3 and it worked

my suggestion is to check with lyen- -*maybe these need to be programmed in a special way not sure* if they're all the same technically they should all work for you, my other theories are goofed up wiring/ wonky flash.. - only way to find that out is to open it up(may not be necessary if it's a programming issue) i've never gone beyond 6fet so i have no experience with 24fet controllers

 

[bigsi]

Sorry my bad. I'll email but he's so busy at mo takes 3 weeks to hear anything back haha. Long may it last for him though

 

[bigsi]

Sorry my bad. I'll email but he's so busy at mo takes 3 weeks to hear anything back haha. Long may it last for him though

 

[bigsi]

Anyone? I can't ride my bike until it's done :-(