Hi everyone,
I am a longtime reader that has just started my own ebike build. I will be using a Vector frame, Sabvoton controller, and a chinese motor that I acquired through aliexpress.com. The battery pack I will be using is a 72V 20ah pack using A123 pouch cells.
The sabvoton motor controller (72V, 3kW) did not come with a cycle analyst connector (6-pin), so I was wondering if anyone would be able to help me create this connector so that I can use the cycle analyst (v2.3) on my ride.
Does anyone out there have some experience working with these two products?
I have the attached connector pin assignment but I am unsure of which wires I should be tapping into from the sabvoton.
Help PLEASE!
I am a longtime reader that has just started my own ebike build. I will be using a Vector frame, Sabvoton controller, and a chinese motor that I acquired through aliexpress.com. The battery pack I will be using is a 72V 20ah pack using A123 pouch cells.
The sabvoton motor controller (72V, 3kW) did not come with a cycle analyst connector (6-pin), so I was wondering if anyone would be able to help me create this connector so that I can use the cycle analyst (v2.3) on my ride.
Does anyone out there have some experience working with these two products?
I have the attached connector pin assignment but I am unsure of which wires I should be tapping into from the sabvoton.
Help PLEASE!