voicecoils
1 MW
Lurkin said:Flange spoke hole diameter: ~3mm
Eyelet hole diameter:~3.3mm
Pretty hard to measure these accurately because the calliper doesn't neatly go into the hole. Will try a bit harder when I get home, just a bit hard at work.
Unsure on spoke lace pattern. Spoke calculations so far have been based on 1X, given the summary on Grin's website suggests more crosses are probably not required. Open to suggestion on this.
The spoke holes do not appear to be angled.
The spoke holes are eyeleted
The depth is decent, pretty hard to tell exactly, will check later tonight.
Ok, so you have reasonably large holes drilled into your hub flange (enough to fit 11 or 12g) and reasonably small holes in your rim (only big enough for ~14g). Your eyeleted rim holes will make wheel building nice but give less tolerance for poor spoke/nipple alignment.
I think your rim hole diameters are wrong because even 14 gauge spokes will usually have ~4mm diameter nipple bodies. Aside from that my recommendations are:
* 1 cross lace (provided the rim is 24" or larger, I don't thing you've stated this yet?)
* 13/14 gauge butted spoke (Sapim Strong or DT Alpine I)