Torque for nuts on a MXUS 3000

[ecologymagnet]

Wich is the recomended torque for a nuts on a MXUS 3000?

I use a torque arm, there isn't risk that the shaft rotates.

Thank you.

 

[Drunkskunk]

IIRC Justin found that some hub motor axles could strip at as low as 70 newton meters (~50 foot-pounds), but gave full benefit to being tight at 40(~30 foot-pounds). I tighten mine to around 50nm (~35 foot-pounds). The only loose nut I've had was holding the handlebars.