Hi all,
So I have a problem and I believe it's controller fault. When I connect controller to battery my wheel show resistance in turning. Like one faze is active. I measured GND to fazes and + to fazes of the controller and I get around 10k ohm Ground to fazes. Display is not even turned on. just the controller plugged into battery.
What error could this be. If there is no short to ground. Hub motor is ok I did checked it. It spins free when not connected. No shorts to casing. Halls are ok all works fine. All cables are ok. Fazes of the hub are also ok, measuring 0.8ohm across fazes. Fazes connected in-between induce power and you can feel the similar resistance as when controller is plugged in.
Thank you all
So I have a problem and I believe it's controller fault. When I connect controller to battery my wheel show resistance in turning. Like one faze is active. I measured GND to fazes and + to fazes of the controller and I get around 10k ohm Ground to fazes. Display is not even turned on. just the controller plugged into battery.
What error could this be. If there is no short to ground. Hub motor is ok I did checked it. It spins free when not connected. No shorts to casing. Halls are ok all works fine. All cables are ok. Fazes of the hub are also ok, measuring 0.8ohm across fazes. Fazes connected in-between induce power and you can feel the similar resistance as when controller is plugged in.
Thank you all