Mark Stosberg
10 mW
I accidentally pulled the XLR connector off the end of my Infineon 35A
controller supplied by Cycle 9. I was glad to find that it appears easily repairable and
nothing was damaged.
The controller labels that the brown wire going out is positive and the
blue one is ground.
My question is to confirm which pins in the XLR that these should
connect to. I might guess "positive -> 1", "negative -> 2".
Could any one confirm? I tried to self-service my answer by hunting for the
controller manual online, but couldn't find it anywhere. Perhaps the answer to this question is specific to how Cycle 9 prepared the controller for me, but I thought I'd ask here for advice in case there's a most-likely answer.
Thanks!
Mark
http://mark.stosberg.com/bike
controller supplied by Cycle 9. I was glad to find that it appears easily repairable and
nothing was damaged.
The controller labels that the brown wire going out is positive and the
blue one is ground.
My question is to confirm which pins in the XLR that these should
connect to. I might guess "positive -> 1", "negative -> 2".
Could any one confirm? I tried to self-service my answer by hunting for the
controller manual online, but couldn't find it anywhere. Perhaps the answer to this question is specific to how Cycle 9 prepared the controller for me, but I thought I'd ask here for advice in case there's a most-likely answer.
Thanks!
Mark
http://mark.stosberg.com/bike