I'm having an issue of when my battery is at 46V the SOC reading is down to 7% (flat) and it doesn't allow me to use the rest of the battery. I upgraded the firmware to the file from Tomblarom, the flashing was completed with success, the system runs but no luck. I set the Min Volt Cut down to 41V or 40V or 38V and nothing. It's all the same.
Anyone having this issue? Is there a way for the bafang controller to learn the full battery capacity? I'm using a 58.8V 21Ah battery. No errors or anything. It just doesn't seem to allow me to use the battery at any voltage below 46V / 45V.
I used a spare battery with 58.8V 16Ah and it was exactly the same.
Any help it would be much appreciated.
Cheers
Anyone having this issue? Is there a way for the bafang controller to learn the full battery capacity? I'm using a 58.8V 21Ah battery. No errors or anything. It just doesn't seem to allow me to use the battery at any voltage below 46V / 45V.
I used a spare battery with 58.8V 16Ah and it was exactly the same.
Any help it would be much appreciated.
Cheers