Hi all
I have an APT controller and the darn thing wont connect to the software. I followed all of the steps..COM port etc but in the program itself the controller status and settings dont show up.
Im thinking of buying different cables rather than the ones that were included.
Its kind of hard to find this particular cable. Do you think it could be a signal issue in the cables?
Im troubleshooting as much as i can. Thanks!
I have an APT controller and the darn thing wont connect to the software. I followed all of the steps..COM port etc but in the program itself the controller status and settings dont show up.
Im thinking of buying different cables rather than the ones that were included.
Its kind of hard to find this particular cable. Do you think it could be a signal issue in the cables?
Im troubleshooting as much as i can. Thanks!