_Stephan_

Keep us posted :)

Pls check Post #25 Used an additional DC Step Up to add 7V Potential (same GND as WEMOS D1 mini) to supply the torque sensor. Works...

Hi BB8 - thanks a lot for your feedback! Higher Voltage is the key to activate the Torque Sensor. Just used a DC-DC StepUp Converter...

Long term tests are not yet carried out. Power seems to be increased compared to original setup, but I think it´s not really doubled...

@graresf: keep us posted! Interested if your bike will be revived! Back to the main topic: DIY Ampler Controller | Ampler Hack | Open...

Hi guys, this is my first post on this forum, happy to be part of the community! So I wanted to share my bachelor project and ask for...

Try this one if you need a switch which stays on/off Gebildet 2pcs 22mm... https://www.amazon.de/dp/B08HCKHLR5?ref=ppx_pop_mob_ap_share

In my setup supply voltage is only 3.3VDC and PAS works fine. Torque won't work with voltages lower than 7VDC. In your case I would...

Thanks a lot! Guess you bought the SBBRT-120L-1-8-708 as replacement (I bought SBBRT-120L1-5-20 as replacement) Originally there`s a...

No experiece w/ Dillinger Pedal Assist or KT Controllers - but would advise to read out torque and PAS Sensor by Arduino or WEMOS D1...

b) "Full Edition" - only once tested if it would fit. Wiring Harness might be little too thick. Technically its working. - µC WEMOS D1...

In the mean time I found some time to continue. 2 Controller Versions build up a) "Light Edition" - fully integrated in Ampler Frame -...