Recent content by Adam271226

Thank you for 46.2 firmware. Are you getting a significant "jerk/jump" in motor power while pedaling and applying throttle? In other versions of firmware application of throttle while pedaling would cut off power for a fraction of a second and then throttle would take over. I tried different...

I managed to buy controller with 46.2 firmware but it is not possible "download" firmware from controller. FW is adjustable and that part works great. I adjusted assist level 1 for 100 w and 2 for 200 w and level 3 for 350 w. Angle adjustment works, too. Acceleration adjustment decreases...

Can someone post firmware 46.2 for m600 48v?

Is it possible to install new controller to "old" motor? I tried to find where to buy newest controller but was unsuccessful. Do you know who might be able to sell them?

Hi 4πr^2, I sincerely appreciate your help. Thank you.

How can we download the new software? The link take you to the Contact page.

Does anyone know if there is firmware update for the torque sensor for M600 motor?

Hi, I decided to make adjustments on my m600 and no one had BESST tool for sale so I ordered it from europe. Tool works on my luna motor, motor with FLX controller and one that came from china. And I tried on it on BBS02. Tool will work on bafang products, the issue is software version. New...

I’ve read that to calibrate torque sensor on M600 motor weight is required on the pedals. Does anyone know proper procedure for torque sensor calibration? I returned my motor to 14.6 firmware and it feels like pedal assist is not behaving same as before when I had original 14.6 firmware. (...

Hi, the center connection is for brake cables. Connector that is in the most rear position is for the shift sensor. To connect shift sensor you will need a cable that has two connections - one for wheel speed sensor and separate connector for shift sensor. Attached is a picture of the cable...

Hi, Luna Cycles is selling shorter pedal cranks. I put them on and it helped out with ground clearance but bike felt strange at first. https://lunacycle.com/luna-x1-enduro-short-crank-arms/

Has anyone experience excessive wear in the pivot joint in the frame?

Does anyone have a source to order just the controller for m600 motor?

Is there a way to “download” the firmware from the controller so it can uploaded to a different controller? I just received motor with 14.5 firmware and I would like to be able to go back to it.

Has anyone replaced the controller on the motor? What is the procedure to pair new controller with the motor? Any help would be greatly appreciated.