AGS

You will need a dc to dc converter and probably a bunch of relays for the lights and indicators, together with switches. The CT22...

The wiring diagrams that I have seen for this display show the yellow wire permanently connected to the battery positive so the display...

Page 32 in your manual describes how to make a cable to copy the parameters from your old display to the new one. But it is unlikely to...

From AGS Build Thread 1984 Puch Maxi Motor: QS205 in 19” wheel Controller: Sabvoton 72100 Battery: 72 volt, 150 amp 50 amp hour

Link to battery https://www.risunmotor.co.uk/collections/rectangle-battery-pack Link to horn...

Here is the auxiliary control panel for head light, tail light, brake light and indicators. It’s just a simple 72V to 12V converter and...

It’s probably time for me to share this build on ES. I started it last November and have made several modifications along the way when...

You can’t buy the orange sleeving on its own because it is moulded onto the cable. So if you want the orange sleeving you will need to...

It is a very soft moulding and easy for it to get cut especially if the brake rotor screws hit it. It’s a good idea to fit a brake...

Don’t plug a 2 pin red brake connector into a 3 pin yellow Bafang socket or you will blow the 5v regulator in the controller. Here is...

I searched for 6 way motorcycle connectors on eBay and found some. I’m sure you can get the same in the US. [Quality 2.8mm Mini...

Ebike Solutions do sell dual mode KT controllers. Here is one of them. Although I don’t see the lower powered version like the OP has on...

What type of hall sensors did you fit?

Surely you don’t need high strength epoxy? I use a small dab of super glue, otherwise it makes it difficult to remove them if they ever...

Mine has two 6mm copper wires for each phase (10swg x2). And has 6mm ring terminals that fit straight on the controller. I used 6 of...