casainho

Great news! I'm glad I could help.

Good news!! 1. I flashed the firmware that improves the motor current on this cheap bad quality VESC (thanks @IsaacLarsen to point this...

That is great!! thanks. I bought the most cheap VESC of 200A on Aliexpress, so I understand why I have motor noise at startup as also a...

That is a very good idea. However, I will only focus on developing what I use and my TODO list is the same as previous. I am also...

When I was using slide regen, which is what you're describing, I had a pushbutton with a simple resistor/pot circuit that applied around...

On the other day, by mistake I disabled charging on the BMS. Then, the scooter would not brake/regen at all and I didn't know why :( I...

I decided to do a rear lights board + front lights board. My front turn lights are totally different from the rear turns lights...

There is no need to have precisely control the throttle, like let's say when you hit a bump and your hand on throttle will change a bit...

I am doing the same as you, using a VESC. I am building a simple DIY display using ESP32, and I even communicate wireless using ESPNow...

I don't know about bigger bikes. Although I have a friend working on electric motorcycle since many years ago. We were discussing the...

The original motor do coast every time I decelerates, and then I feel out of control - to have control again, I need to keep increasing...

I was getting false buttons clicks on the display buttons - I added low pass filters and now they work well as expected. This is the...

Can you please explain why coasting is important?

It is just the speed controller of VESC, that is a PID controller. The throttle position defines a target speed - on my case, I set from...

The EScooter DIY Lights board I am building. It will control my Fiido Q1S lights for: headlight, tail, brake, left and right turn...