Recent content by dos bikers

Hi guys does anyone know the name and where to get the screws that hold the nylon gear plate down on the bbshd 1000w. There's three and I've stripped one out. Looked for a long time can't seem to find any info on them.

Hi guys does anyone know the name and where to get the screws that hold the nylon gear plate down on the bbshd 1000w. There's three and I've stripped one out. Looked for a long time can't seem to find any info on them.

Hi I took it all apart and could not see and burning. I heat struck two of the phase cables that looked a bit rough. I put it back together still didn't work. Then whilst testing the power cable came off and there was a puff of smoke. I think it shorted. After that it works fine. Auto tune ran...

Its mounted outside. I will take the motor apart again tomorrow and have a good look thanks for your help

Hi it just cut out and didn't come back on. when testing it the fault came up over phase current. I've tried different maps and it spins then cuts out. Also cuts out when under load. Maybe it got hot on a long hill climb I did because it stopped after that. Is there a way of seeing this if I...

Hi guys bike working perfectly with bbshd cycle analyst and phase runner. Suddenly not working. Put many different settings in from guys on here with no results. When I run auto tune the motor just judder round. I sometimes get over phase fault saying to adjust Hall sensor or kp and ki. Have...

Hi guys I have cycle analysist phaserunner and a 52v battery. Everything was fine for a year then suddenly stopped working. Power comes on then when you use the throttle very little power comes on the wheel doesn't move unless you pick the back end up. Then it cuts out. I've run a test in the...

hi guys im new to all this. i have a bbshd with phaserunner and cycle anylist. ive been searching everywhere for some set up screen shots but nothing .ive tried to basic set up but its not that good. does anyone have some settings i can start of with. cheers