Recent content by GooseRider

Sounds like your hall sensors are bad, not connected, or shorted. The first bicycle I put my hub on had a spinout and the hall sensor ground got ripped from the controller, it just clunked a whole bunch and wouldn't move. A quick solder job and a new bike with dual torque arms and I was back in...

I just use some cable with enough slack to get on/off. Definitely looking at changing to a coiled cable though. Either way if I go flying off, if the xt60 doesn't pop off, the solder on it probably will.

PM'd you. Would be nice to have a backup battery.

It was my first time soldering since high school computer engineering class... Glad to hear I'm most likely ok. Haven't been this pumped since I rode my motorcycle for the first time! I'll definitely be back to tell you guys just how fast the ol' chinesium special goes.

So I'm finishing up my first build. It's an ebay hub motor with a 35 amp peak controller. It was dark, I just finished soldering the last connections I needed on the battery, and I was excited to hook up the motor just to see it spin. I had attached a female xt60 to the male xt60 coming off my...