Recent content by guf

Have you finally been able to find an easy way to pry the FET springs back to remove and reinstall the board easily ? I have a couple of GEN4 drives laying around that need some repairs. Guillaume

I understand what you're saying. Thanks for your input.

Yes, you're right. If I read the C63 spec correctly, it should trip in around 10 seconds at 157.5A. This is OK for me. I don't think I'll use 160A for more than 10 seconds, it'll be probably less than that.

Thanks brumbrum and litespeed! I will get a single 63A breaker afterall.

Thanks brumbrum for your feedback. It looks promising. I am expecting to reach 160A battery peak current. I was therefore looking for a 125A circuit breaker that would trip in around 30 seconds at 160A. Can you point me to this 63A recommendation you are referring to (thread, website...

I'm wondering if I could only use a fuse and NO DC circuit breaker on my Adaptto setup. If a short or an overload happens, the fuse would blow and I'd replace it. This should not happen unless something goes wrong (or my fuse is undersized). I was initially planning on using some sort of...

Also, I'm not sure about frame geometry and what is best for me. Is there a preferred geometry to look for ?

Hello, I am new to ebikes and I am in the process of building my own for the first time. Apart from the motor, I have not made a final decision on any other parts yet. I have received the motor from China recently, it's a MXUS 3000W V3 that should fit a 135mm dropout. It is laced on a 26 in...