rivvs

I have 6.18-1 gear ratio. I think with tuning I should get more speed. I think something was getting hot because after several...

Si Ennoid repaired the slave board and now it works. Only problems Is that it will not charge because the bums need to see voltage at...

If you want to read more about the Ennoid you need to look on the many electric skate and one wheels forum. I have used the master lv...

I would suggest to stay away from Ennoid. So far I have had: Master bms bricked during first setup Master bms fried during precharge...

Yes the wiring is good it worked with the previous bms. I took the slave out and they seems defective. One has the led always on and the...

Yes I had asked him and he tested it with my master xlite before sending it and it worked. I set him an email and he said maybe try...

no I changed to the xlite master. I guesse when the LV burned it problably burn the balance board too

Yes with bms test it fail every test. What settings did you find that can throw off the voltage reading? I think I set it up right or at...

Update on this bike build. After over 2 months of now doing anything I started working on it again. Got hackey to tune the cl1000 and it...

hi, jbjork did you make a cover to protect the controller from water/mud? I just received my cl1000 and I will need to mount it where...