Recent content by Ronin

Thanks for links and info, the steerer tube is 41mm wide and 120mm high. not sure about the bearings, know there are many many many standards Anyway, ready for a forkhead cut and replace tig opereation if necassary, I Think the operation to get the motor axle to hold torque and not slip will be...

Ok, so I have ordered a new fork I will try to fit. https://www.ebay.com/itm/630MM-FRONT-FORKS-SHOCKS-FORK-SET-ASSY-SUSPENSION-33mm-Triple-Tree-Clamps-Set/253378947569

So I just found these 2 pipes of hard steel from a not working garage jack, not so very heavy but dont think I can bend them easily. They fit perfect into the holes in the fork. Have to hammer them down the last part. So how long down should I jack them down? All the way to bottom, 20cm? And...

Thanks for your input, was thinking a lot about this, and even this fork seem to be built with bigger and stronger materials I got an idea instead of finding another fork... Cut up two stainless pipes that fit perfectly down the holes and attach somehow on the handlebar. Maybe weld it tight on...

I can understand you say that, but the front suspension is locked and will never extend. Also planning on welding it together but dont feel that would be neccessary. Also a very strong fork, in best steel. Therefor i dont want to change it unless i get a special made mc fork which fit the wheel...

Joining the kff-club :bigthumb: :oops:

Little more details on brakes and wheel anti-torque bolt plates. Impossible to turn axle on the frame, don't know how much Nm it can take but 10mm stainless on back wheel and 6mm on front wheel, tread in holes fit perfect for the 10x16mm axle. I see I have to fill some weld into axle hole or...

Hehe, yes its a beast. Of course, cables will be set up very nice maybe behind some lists or something, I will figure it out after finished building. I am thinking to keep the pedals, better to take curves when you can lean right foot forward or backwards, after how the curve and speed is... And...

Here as it is per today... too bad i cant use this motor... yeye

Little more detailed. Also double disc and calipers on front wheel.

here is a picture of the bike btw... :) 6 54volt batteries mounted on stainless plates. The horns was just an experiment and have taken them off...

Not going to burn any controller or motor, will stop testing with the combination that runs motor fast. I did it easily so no worries. So I am thinking about selling the QS and get something like this 3.5T motor...

Ok, learning the expensive way here... got an answer from Kellystore... "The speed of the controller: 1. High-speed or ultra-high-speed controllers will not affect the rotation speed of the motor, because the speed is determined internally by the motor. Therefore, if you choose an...

Ok, so now I learned the hard way exacly what the difference between 3.5T and 5T is for real... I read a lot of it before I bought motor and controller, but not enough though... So this is the thing, when I use any of the controller on the QS motor and let go of throttle, it breaks a bit and...

Thanks but there are just a very few parameters to adjust in KBL software... I bought the 5T motor. I have also tested my other controller on the QS motor, with kelly controller connected to my front motor, and even when I spin my QS motor with the other controller the kelly controller gets 3-2...