Recent content by Scotty T

I'm on another forum that uses Xenforo, I think it's the best one around.

The neighbour ended up with an e-trike so my son has started using this bike. With the new battery it continues to chug along, doing a short 7km round trip for work each day. It has never skipped a beat, and I pulled the old battery apart to salvage the 18650's but am yet to use one in another...

Hi mate, been a long time, I've finally joined the mid drive brigade and my old hub drive is still kicking along on my big cruiser. I'll post another thread on the bikes I've built for myself and my wife but I have a few comments having bought the Cap Rouge 250w and 500w kits. Do you have a...

It would be great if you could override PAS by twisting the throttle. It would mean you could twist the throttle and it would just go when the previous issue with the speed dropping way below threshold when encountering a hill after being over speed for a bit. But what kind of switch, it surely...

There is an improvement when going up hill or on the flat, it no longer speeds right up and over the limit dropping off and surging again, it will hold around +/- 0.2-0.5km/h of the limit with the settings I've described in the last post. But I still get the long delay after it's been coasting...

Thanks mate, I've had a little bit of luck playing with speed limit gain settings, and I've left my PAS and throttle ramping as they were because your setting off 99v was too much off the line. I've arrived at PSGain 2v/km/h, IntSGain 70 and DSGain 90. It seems pretty good, I will need to take a...

I'm so close, but this delay in coming back after speed limit is driving me nuts. Expected behaviour: Drop below speed limit, it puts some power in motor, not much just to maintain speed limit. It responds quickly, within a drop if 1km. Actual behaviour: Drop below speed limit, nothing, until...

Fast forward all these years, it didn't get ridden since about 2016, a handful of times and each time the battery became worse, getting down to under 20km range on low PAS. Very disappointing, so the bike got packed away. Fast forward and my neighbour has back probems and no transport so we're...

I have arrived at three presets, with those on the digital aux switch, and speed limits on each, and the pot adjusts the limits. I was finding it slow to bring the power back after coasting at speed then hitting a hill, it would lag until the speed was a few km below the set limit. I looked into...

So a fair bit has changed, the Mongoose is on its way back to bieng a vintage MTB and the kit has been put on my board tracker style cruiser. It's really great to ride, 23km/h you run out of RPM in the legs so might play with the gearing as it's single speed and I can possibly go a little bit...

Thanks so much for this info, I have now set things up and it's a whole different bike, I had to drop all my limits as it took off like a rocket, I'd forgotten how punchy it was because of these issues after my firmware change and subsequent config overwrite. I've found a very faded 4.19...

Thanks for the tips @DanGT86, I'll check that shunt value, I think it may have changed when I upgraded firmware and overwrote a setup.

Some obeservations and questions... If I limit amps or watts with power limits I get surging on the throttle, it seems to not like power limts in my setup. PAS is working really well, just having trouble on a different crankset getting the magnet ring to line up. Running it start stop for...

I've moved my CA to a new bike and played around with settings, turns out I was limiting amps and watts which was causing the throttle issue of surging so removing those limits fixed that. Also throttle out voltage was too high for the controller so I dropped it a little and all good now. Have...