Recent content by Sean9002

Was the DNM rear shock over pressurised? Ive had that on an RCP2. All the others seem to be spot on.

That incredibly shitty looking charger should be alarm bells for you! Cheap and nasty. :(

It should do the job, the 48v will have some head room so your 52v pack shouldnt be an issue. You will need resistor going between the two large lugs (battery terminals) and a diode across the switching poles (the two small posts) On mine im using a 10k resistor and a 200v 3amp diode.

Add a realy/contactor so you can switch high voltage with a low voltage switch. http://kellycontroller.com/contactors-c-32.html

Welcome mate! keep us up to date :bigthumb:

have you measured the steerer angle? it looks very steep, almost like a trials bike :shock:

Haha, My thread has been kicked off again! love it. Love trials. I'll have to go back through and have a read about what everyones talking about. great to see some trials builds, I think theres only a few of us that have done such builds and theyre all usually pretty experimental. I see a few...

Any idea what the weight will be at the end? I like this style of frame..the curved sections remind me of 'Pie Cuts' when welding up exhausts!

i run the same frame in! love the suspension on the Maestro frames :twisted: any reason your on an air shock instead of coil?

So i had it right years ago when i was using spindle drive on my scooters =)

have you looked at griphsifts? run one upside down on the left side. its awkward but if your just shifting every so often it does work well!

Looks way better with thte 888's on the front! that front tire looks a bit anemic compared to the rest of the bike now =)

can you explain that rediculous seat? It looks like it wouldnt be too friendly on the base of your "old mate" :lol:

Of course this can be done, but you would be better off spending a couple of bucks on a new BMS specific to your task. If your going to build a battery (not a cheap process) do you want to risk it by skimping on using a BMS youve desoldered from another pack?

This might be a stupid question but it was the first thing that came to mind...are both VESC's running the same firmware? Ive had two that ive purchased at the same time, that were running different firmware.