Recent content by socrace

Did some research into breakers and found Square D QO breakers are rated for 48vdc, upto 50amp and only about $15. Current ratings are NEC standard, which is infinite hold time, with about 100 sec at 4x and 100msec at 10x. Resistance is pretty high though, about 100mohm for a couple used ones...

The giant thread CA v3 preview has a long list of helpful index links on the first page, but virtually all are now broken (including first 2), or is this not Xenforo?

Yeah, sold my goldwing bobber last year and switched to this safer alternative. Oh well. Next high speed run I do will probably be on a dynojet. Kinda expensive, but cheaper than an er visit.

Ran across this post today, and need to say this 98mph Grin simulation just can't work! The Grin page probably needs the "simulate" button pressed, in which case the 8.1kw motor power will yield about 60mph (where load and power lines cross), not 98mph. 60mph is what my 24s build does...

Have gradually increased volts over time from original 12s lion to current 24s lipo, or about 100v max charge, Have found the ca is really necessary at these volts. Using a hall based throttle is not easily controlled otherwise.

Uneven idle speed and dragging clutch can slam the freewheel back and forth and destroy the freewheel pawls pretty quick, especially with centrifugal clutch, but maybe lever type also. Might be able to see it when idling.

Been using this cheap amazon stand on my sig ebike (55 lbs). No problem testing in the living room at 60 mph (after some mods to stand): https://www.amazon.com/gp/product/B075FC2LBX/ Mods to stand: convert from adjustable to fixed size, to add strength (drill plastic ends and insert a bolt on...

Hey ZhakirSetie, Can't answer your question, but wondering why your signature consists of links to fake local router address, intentional or what?

Here's a sketch of my ca3.1-wp-mfs. Mainly opened it up to see where the buttons connect to internally, also to estimate a current rating for the power switch. It seems to use an active switch built in to the housing. The up/down arrow keys connect to 2 different resistors to ground. Working ok...

In the US: https://www.dimecitycycles.com/motorcycle-parts/motorcycle-fairings-bodywork-and-license-plates/motorcycle-fenders.html

For those interested, some more (deep dive) technical info about the above Infineon micro posted by philf earlier in this thread. This is likely a close variant of the Infineon XC886 processor, a quad package version of the dual sided XC836, both of which are still very popular in Chinese...

If you want to live dangerously, just touch the yellow and blue wires together a few quick times and see if the motor turns. This could fry the controller, though, if red is not the power wire. Verify that with a voltmeter first (that red has the highest voltage to ground).

Measure voltage, current draw and rpm at max unloaded motor speed. There is a possibility that the new 3000 watt controller is wired incorrectly https://endless-sphere.com/forums/viewtopic.php?t=3484 , plus this information is needed to allow basic calculation of the motor's theoretical...

I found you really need a good soldering gun like the Weller D550, which is 260 watts, about $35. I built this a couple months ago, 65 recycled LG batteries + holders cost just under $100.