stancecoke

Yes, this is the recent way to use the original Lishui firmware update tool. There is a german tutorial in the german Wiki...

That isn't possible, the processor is read out protected. regards stancecoke

There is a long thread in the german forum...

The Eggrider Homepage provides this drawing: So connect pin 1 to pin 5! You can easily find the GND pin, it has 0 ohms to battery -...

Yes, there are reports of users who have succeeded in removing the potting...

You have to connect the blue wire to the red wire on the display cable to switch on the controller without display. The 5s protocol has...

Lishui has several different board layouts for the same schematic. You will find two transistors somewhere on your board labeled with Q1...

There was a series of Lishui controllers with weak level shifting transistors. @Agressor110 described how to solve this problem in the...

There is an open source firmware available for the Kunteng controllers, but it only works with sensored motors. regards stancecoke

I've analyzed a system of an Ananda controller and a Bafang CAN display (from a hub motor bike) some time ago...

@stancecoke I was tinkering with the code in the EBiCS_motor_FOC repo for the last couple of days and managed to get my ecoride to run...

maybe the Keyde P110 system is what you are looking for. Very simple to install, just one wire from the motor to the battery. No need to...

No, you don't have to open the controller or have to solder anything with the Phoebe Liu set. Just plug in the torquesensor and start...

The Lishui 12FET is a good choice, a firmware-update may be necessary to get a access to relevant parameter settings. No, the cycle...

There is a complete set at Eunorau...