Recent content by stwi4602

I think I just switch the white wire for the orange one. Since the orange one is labeled ntc.

S ok if I assume the orange wire t that goes nowhere is label ntc at one end. That would mean the white wire is the other end of the ntc.so I should connect the orange wire with ground?

I just changed the resistance values to make the temp match. No orange or purple connected. The orange one is labeled ntc has about 10 volts.

Yea those diagrams don't have the purple and orange wires in looking for. The orange one has about 10 volts on it though.

Ok here's a couple pictures. The motor and the controller.

Hi. I have a hub motor with "extra" wires coming from it orange and purple. Im using a flipsky 75100 controller. Trying to get a correct temp reading from it not -73C. I know that the orange wire is connected to the board marked ntc. How would i utilize this orange wire. I cant see where...

Thank for the advice. It wasn' the battery or the connectors because I changed the controller and the motor and no longer have this issue. I use those warerproof julet connectors . And yes loud and weak..

My ebike hub motor only runs good every 1 of 3 times if I cycle the throttle %100. It's been like this with every controller I've tried. By runs good I mean quietly and more powerfully.