heyDD-
It sounds like a button or perhaps condensation problem that is causing phantom button pushes. In particular, holding the left button depressed on boot sends control directly to Setup - you primary symptom. Buttons not working is likely because one or more is stuck ON.
Carefully...
Okay - added some notes and a more detailed illustration above. There are precharge calculators on line if you happen to know the cap values in your controller...
What he said ^^^^^^
Here's a simple hookup that just uses a mix of one an two pin connectors. Easy with either Anderson PP or RC bullets. With a little heat shrink sleeving it just looks like a short Y on each side.
20-22ga is more than adequate for the precharge wire - the size is more to...
I originally proposed using the hubmotor because of the fabrication simplification and the ease of upgrade - just buy a more powerful motor and bolt it up. The dropout mounts and brake disc offset are standard so no/few issues regarding interchangeability. A consideration will be the size...
The grossy asymmetric Sempu waveform in combination with the high pole count has been found to cause certain CA 3.1+ PAS difficulties. This isn't directly related to the odd pulse timing your post illustrates, but it's another Sempu weirdness.
This issue has been addressed and will be released...
Just a question of getting front wheels from a bigger motorcycle instead of a moped. Box the wheel with an outer strut to carry the other side of the stock motorcycle front axle and things get simpler. Likely needing brakes on the side wheels is an unfortunate complication, otherwise common...
Improved visibility has only do with knees, feet, and pedaling in that they provide points of visual complexity and change for others.
Tying lighting to pedal motion misses the underlying cause of the Trek observation and suffers from the rate dependence you point out. If you want to get...
I don't understand the references to resistors and the throttle connections... The other stuff looks ok.
Here's how to hook up the 3-pos switch using the colors you report:
Chalo has lots of experience with pedicabs and could steer you to rugged wheels/tires for things in this capacity of the bicycle type, but for a scratch build I would lean to moped tires and matching wheels for the two primary wheels since weight is not an issue (puncture resistance). Fat bike...
Basically what neppy said above - two would be the best situation...
But - regardless of voltage, your 20A controller is probably only going to provide 50 phase amps which is not really driving the Mac hard so you don't have an especially bad torque situation just because it's geared. If you...
This could simply be a failed button assembly with the left button stuck ON.
Remove the four screws from the back of the case and carefully open it. Unplug the button ribbon cable from the circuit board. Now try powering up the CA to check if it boots properly.
If this works, a replacement...
:lol: Not only can I read it just fine, but I actually understand it - their policy regarding delivery is quite plain:
You were not ripped off but you are possessed with some need to blame someone. Sometimes everyone does their best, but stuff happens anyway and no one is to blame (shocking...
It's always distressing to see someone become a member of ES because of a sudden burst of 'Public Service' to warn others (aka 'throw a tantrum', 'get even', 'damage business') with a post that will live on for years to come.
You requested special delivery handling directly with the carrier...