Recent content by vipertriplex

Was wondering if anyone has any information concerning Adaptto. I have a couple controllers I wanted to have repaired but under the present circumstances they find themselves in are they still preforming repairs? Tried accessing their website, “Dead” Sent them an email, “No Reply’ Anyone...

Do you have any frames available??? Winter project coming up and always wanted to build up one of your frames…

This was my first choice as well as I have 2 smaller race packs that are simply outstanding. Seems Im not the only one that thinks so as my supplier always seems to be sold out. Thanks to your reminder I just got off the phone with my supplier who will be receiving a restock in the coming...

I would certainly like to thank all you guys for your input and ideas. Seems the I's have it on the Dump Truck Pack which is going to require the reading of a few more threads to insure its done properly, along with the help from a few of you volt/watt speed freaks. I I found your remarks to be...

Hi Guys, Been working on a dual motor project bike over the winter incorporating a front 3k motor and a rear 5k motor. Both being powered by 2 linked Adaptto controllers Mid-Max. The build worked out great and now its battery time. I intend to run this setup in 32s utilizing Samsung 40T 21700...

Hi Guys, Seems my Hall Sensor cable was accidently cut and discarded along with both connectors during a harness change. I have some 6 pin Higo I can use to replace the connector if someone knows the color wire conversion. This is the wire from my Max-E I need to convert to R,B,G,BLU,Y,W Thanks Guys

Thx amberwolf… PMed him...

My first Adaptto was a couple of years and I did a walkthrough with DR. BASS https://www.youtube.com/watch?v=-cmNtBS-n9k He does a good job of explaining the workings... Hope it can help you as well..

I have a mid drive project I would like to do and would like to use a Davinci Drive. seems their web page is gone and their contact number 847-756-4000 connects you to another company... Does anyone have a way to contact them? Thanks Guys

Yeah, strange indeed but with a happy ending... I tried it all. Went from re soldering hall to all connections. Even swapped out my phase wires. Couldn't understand it. All seems fine until it goes into high speed calibration then BANG!, in reverse. Now I realized that every time it does it that...

Hopefully someone can tell me why my motor immediately jumps into reverse when its about to go into high speed calibration during Autodetect. Ive run auto detect once before and completed successfully. Ive tried id again after having the controller serviced and now this... Has anyone ever...

No need.... Figured it out... Should have checked my wiring ONE last time...

Just got around to installing an Adappto BMS to a pack of Li-NMC cells in 23s... I triple checked all my wiring, then checked once more only to find that the bms stars to get warm during installation. Each time I connect the ground to one of the balancing cards it begins to get warm... I was...

Thats just awesome... Bench seat is a must so you can share the ride with your sweetie... An occasional poke in the ribs every now and again might get something started...

Thanks for getting back to me Alex as I did review the post you suggested. I take it you say I cant use the pack because of the way the cells are inadequately paralleled for the demands of the controller. Ive researched different packs but figured I just use the backup pack from the rig I...