Recent content by Volts

There’s a guy on you tube that’s done this and says I works, I don’t know how successful he was with it in the long term

Has anyone here hijacked this controller for more power, either taken one of the phase wire out of the blue square sensor or soldered extra wires at the phase wire source point on the circuit board connecting straight to the motor phases?

Anyone else here have a 96120 controller? Was wondering what battery max people are using on this controller 22s, 23s or 24s.

The 96120 controller can run 24s but both motor and controller gets hot fast, I’m at 23s at the moment and it’s cool/warm and is acceptable but my guess is 22s would be the best for 96120 controller. I haven’t tested 24s on the 72200 version my guess is it would run hot stay with 21s I’d say.

Will a 27.5 fork fit a 19inch moto wheel?

Anyone here know the spoke length to match a mxus 4t to a 18 inch rim?

Does anyone know the spoke length for a mxus 3k hub motor to a 18 inch rim?

I’m currently running a 24s battery on a 96120 controller and have noticed it runs cool until regen kicks in then things start to heat up, was wondering if removing 2cells and running it of 22s would fix the problem?

Ok thanks just wanted to know that it could handle more then 100v without problems, I’m hearing talk on the forums that a lot of controllers get hot with a battery that’s over 20s I know my mqcon controller does. Also why is their a don’t buy on the blog update title? When most of the reports...

can this controller handle 100v on a qsv3 setup without getting hot?

Does anyone know if the wrong programming setup makes the motor and controller run warm?

Cant seem to make my controller run slower changing the DC currents and the phase currents, only works when changing the motor speed percentage but this makes the motor run hot, any input would be helpful I’m running a 96120 controller

Does someone have the sabvoton windows software and if so can you post a link or send it to my email, I’ll let you know it (my email) when you can confirm you can send it thanks

Did you guys end up passing the motor test? If so explain what you did, I too am having the same problem, I’m getting a hall reading of between 1-6 and have checked the output reading on the halls with a multimeter they seem to behave correctly, switching between 0-5V I’m lost at the moment and...

Ok got the controller paired to my phone via the Bluetooth module, the next step is to do a hall test, which setting should I change I’m testing it at the moment on 15amp and it just cog there for ever help needed