Recent content by wez

  1. W

    Battery Charger for 36v

    It seems to be a standard battery pack with built in battery management system and round ~5mm plug. In that case this should fit. Send them an email to verify. http://dillengerelectricbikes.co.uk/spares/electric-bike-kit-spares/chargers/36v-lithium-ion-battery-charger-by-dillenger.html Best...
  2. W

    Nipple size for Sun ringle MTX33

    Hi! I am lacing a hub motor wheel for the first time and I am not sure about the nipple size for the wheel. The motor is a direct drive hub motor and the rim Sun ringle MTX33. I will order butted 13/14g spokes. When I checked for nipples (14g) they are specified for 3.5mm rim spoke, but the rim...
  3. W

    10s 41v charger, where to find?

    It should also be possible to connect one or several high current diodes in series to lower the voltage by 0.7V/diode. There vill be some loss of charging power, but it is not that much (0.7W/ampere). Then you have the possibility to charge to 42V by disconnecting the diodes. Andreas
  4. W

    BBSHD controller on BBS01

    Ok, thanks!
  5. W

    BBSHD controller on BBS01

    Hi! Does anyone know if a BBSHD controller will fit on a BBS01B motor and if it is possible to run a BBSHD controller on 36V. (I would get a good deal on a BBSHD controller) Andreas
  6. W

    Programming the Bafang Middrive BBS01+BBS02

    Hello, I am planning to build a custom controller for my BBS01 based on a Raspberry PI. Does anyone know if there is a way of reading the rpm of the motor or/and the cadence via the serial interface (Bafang protocol v.4.0)?
  7. W

    Programming the Bafang Middrive BBS01+BBS02

    Hi! Just managed to connect to my Bafang BBS01 with a Arduino UNO microcontroller acting as a usb to serial converter. I had a hard time finding a programming cable in Europe and had an extra Arduino at home so I tried this out. I communicated with 5 volt TTL levels. This is how I did: 1...
  8. W

    Cruiser

    Hi, Here are some pictures of the battery box.
  9. W

    Cruiser

    Hi, The battery box is made of sheet metal since I wanted it to be somewhat fireproof when charging the pack inside our house. I gas-welded the box with "edge welds in flanged corners" so you´ll need a sheet metal bender. I got 6pcs 5s 3000mAh batteries and power- and balancing cables to fit in...
  10. W

    Cruiser

    Here is a cruiser that I built last winter. The build went well except that the last coat of clear coat caused some chemical reaction and destroyed all 6 coats of primer, paint and clear coat… so I had to bring it to a professional painter…
See more
Back
Top