Magsy
10 mW
Thanks for taking the time on this code, it has real promise.
Would you be so kind as to refresh/re-upload the pi image please?
Would you be so kind as to refresh/re-upload the pi image please?
Would you use "remote assist mode" address 506?Thank you @xenodius for this project. I'm planning to build a "translator" by a Bluebill board, so you can use common displays with KM5S protocol. So the Bluepill will translate from modbus to 5S protocol.
I can't find the information, how to set the assist level by modbus. The adress 339 "Assist level" is read only, if I look at the XML file
Any idea?
regards
stancecoke
This only works when the assist mode source is set to remote/MODBUS, this is how I control assist levels with my display. Also be aware of the Features3 bitwise switch, 'throttle bypass assist level'.Would you use "remote assist mode" address 506?