Search results

Date Relevance Most replies

  1. W

    Baserunner throttle issues

    Hi there I have just installed a Baserunner controller for my Ezee 250rpm motor. I have uploaded the Ezee motor and Baserunner parameters into the controller. I am not getting any voltage change or wheel spinning when I twist the throttle. It remains at 0.05v whilst the brake voltage increases...
  2. W

    Baserunner Fault Code

    I have just installed a Baserunner controller for my Ezee hub motor The controller and all associated wiring has been installed. I opened up Phaserunner suit on my laptop, downloaded Grins default parameters, selected my motor (Ezee 250rpm) and the Baserunner V4 L10 controller and loaded the...
  3. W

    BBS02B controller.

    Hiya all. I was riding my BBS02b a few months back and parked the bike up after the ride. All was good with the world 😀 4 days later I went to go for another ride and the unit wouldn’t fire up. No power to the display and no response from the controller when I plugged my laptop into it. ……. So...
  4. W

    Ezee motor cutting out

    Hiya all. Just after your opinion on this issue I have. I have a rear Ezee motor, Ezee 25Amp controller and 48v battery. The motor cuts out when I pull away giving it full throttle. The wheel starts to turn then after about 0.5 to 1 revolution it stops. There is still voltage at the inline power...
  5. W

    Going from Hollow Tech crank to Square Taper

    Hiya all. I have a cranky knee. When I was running my BBS02 I was able to use 150mm cranks which pretty much sorted my knee pain after cycling. I have gone back to a hub motor because of BBS02 controller problems and have had to refit my old 170mm hollow tech crank. Immediately my knee soreness...
  6. W

    Help with Cycle Analyst

    Hiya all I have just bought a CA V3 DPS and am in the process of setting it up. I don’t yet have the auxiliary switch. I want to set up 5-6 PAS assistance levels but am unsure if this is possible without the Auxiliary switch. Any advice?
  7. W

    More power from an Ezee motor

    Hiya all. I have an Ezee 26inch front wheel conversion kit (V2 I think) on my bike which runs at 48v and has the 20Amp controller. I was considering buying a new, higher power kit to replace it but was wondering if there are any compatible parts that can be plugged straight in to up the power...
Back
Top