Search results

Date Relevance Most replies

  1. O

    Food cart motor power requirements

    I'm designing a food cart designed around a 3x5 foot stainless sandwich prep station. Total weight could exceed 400pds. How much motor power would I need? Figure 250-300 watts per hundred pounds? First attempt with a 2'x4' with 26" wheels burned up a 500watt motor pretty quick. (My son...
  2. O

    Identify this connector?

    Purchased this motor from and ebay seller. It purportedly is a Suntour Motor manufactured for Raleigh and seems to be no longer manufactured. Problem is I can't seem to source the 9pin male connector from the motor. Before I cut it off and replace with something more standard, can anyone...
  3. O

    Installing a BMS

    The new battery showed full charge on LCD display but would not run motor. Connecting voltmeter across positive and negative of controller input,(battery output) meter could not settle on a voltage OL...... ) before BMS read 54.1 volts. . Decided to change it but the new one had no switch...
  4. O

    CA3 10 volt regulator pt #

    My CA3 is showing 53volts on the 10 volt output. Need a good part # for the regulator. Can find mostly 7800 series regulators which are only good to 35 volts. #'s on case DN2450 16 7C8W Elongated S (Sigma ?) for manufacturer symbol.
  5. O

    Installing Bafang Torque sensor

    Is anyone familiar with a Fuji bottom bracket? I was attempting to install a Bafang torque sensor (24tpi) into my Fuji Navajo bottom bracket and the threads seemed to be different. Threads seemed to start OK but got very hard to turn towards the end.
Back
Top