Search results

Date Relevance Most replies

  1. Y

    Cycle Analyst rebooting when headlight turned on.

    Amberwolf Thanks again for your input on my issue. After a couple days operating with the SPL-01 headlamp my CA is working fine. It was just coincidental that it failed when I made all the other changes. Ezee to All Axle hub, adding thermistor, opening and converting my CA from DPS to DP and...
  2. Y

    Cycle Analyst rebooting when headlight turned on.

    CA Rebooting It appears the Roxim headlight is the cause of my rebooting issue on the CA . After duplicating the fault fairly consistently by cooling the headlamp and not being able to get the CA to reboot when light turned on to then heating the headlight again and then at a certain point it...
  3. Y

    Cycle Analyst rebooting when headlight turned on.

    Becoming a little like a murder mystery. This morning was a little cold so bike and equipment was below 10 degrees C and I was unable to reproduce the fault. ( Makes me think temp related ) I waited till the sun heated up the bike, headlight, CA and Battery etc with hub temp about 13 C as...
  4. Y

    Cycle Analyst rebooting when headlight turned on.

    Amberwolf Thanks for the reply. The light is the Roxim unit Grin sells and Peak watts is 5.5 in the specs. My Battery pack is a 52volt 16AH. I think I had thermistor and hub disconnected and it still rebooted but I will verify this again in a day or two. Tim
  5. Y

    Cycle Analyst rebooting when headlight turned on.

    Hello Have an issue with my CA rebooting ( Screen blanks and then powers back on ) when the headlight which is switched ON. Light is approx 2-3 watts and plugged into CA acc plug ( CA Ver 3.13 ). Had one instance where the stats where lost but most times it just reboots and comes back on...
  6. Y

    BBSXX Programming connection issue

    One other thing I just remembered in addition to the original post is I set the recommended baud rate to 115200 for the CP2102 USB-TTL adapter I have been trying.
  7. Y

    Hailong 3 Battery Case?

    Thanks for the info Ebike.ca got some in so being local it worked out well for me to pick one up directly.
  8. Y

    BBSXX Programming connection issue

    Good Day New to the forum so hello to all. I have run out of ideas to get my BBSHD controller to hook up again with my computer. Made two sets of changes which got me closer to a perfect setup and was ready to make my final changes and was unable to reconnect with my controller. Original...
  9. Y

    Hailong 3 Battery Case?

    I sure hoped for a solution as I am in a similar situation. Didnt think getting a spare Hailong frame mount to swap my battery between my commuter bike and my weekender bike would be so difficult. Removing the screws and tie wraps to swap mount to other bike every week is a pain and another...
Back
Top