Search results

Date Relevance Most replies

  1. Zeggi

    TSDZ2 - Torque sensor calibration ADC?

    Ok an update. Since I haven't been able to try the bike untill today, did the calibration 3 days ago. My torque sensor menu setting i have calibration set to enabled and my settings are still there. I entered technical menu and when I did I got following error code which is the first time I...
  2. Zeggi

    TSDZ2 - Torque sensor calibration ADC?

    Hey all, I have a 52v TSDZ2 750w (according to sticker). I've used it with the stock firmware, upgraded to the kt-lcd3 and now a few months ago I'm using the 860c with latest OSF 1.1.0 . I've replaced the front 40T sprocket (chainring) to a 52T. Stock crank arms. 14s4p Samsung E35. Now to the...
  3. Zeggi

    TSDZ2 mid drive with 860C, 850C or SW102 displays only -- Flexible OpenSource firmware (Casainho code only)

    I would suggest hooking up a multimeter and measure the voltage from the buck converter and raise it to the limits you need. Mine seemed dead but once I measured it was at only 5v and there is a small screw on top of the adjuster, just screw it and measure again. Mine is at 28v and worked...
  4. Zeggi

    TSDZ2 mid drive with 860C, 850C or SW102 displays only -- Flexible OpenSource firmware (Casainho code only)

    Started new thread instead and can't find a delete post function.
  5. Zeggi

    New "TSDZ2 Torque Sensor Central Motor"

    Well with the firmware you can set it to your liking. I'm using the 52v 750w version with battery; "14s4p 52v 14ah/17.5ah 500-1000w " Samsung 35ET Max charged at 58.6-58.8v Cut off set to I think it was 10-20% 46.3-47.6v Power set to 750w
  6. Zeggi

    KT-LCD3 issue, wires behind board?

    Well I'm mostly pissed ln the fact that a new device comes in that condition... Sigh
  7. Zeggi

    KT-LCD3 issue, wires behind board?

    My bad, never noticed there was options below this window :) As for the issue, I figure I need to remove that sealent plastic holding wires in place so I can get card out to see where the wire is supposed to be. I got a glance of the board and noticed all wires are soldered in line and there is...
  8. Zeggi

    KT-LCD3 issue, wires behind board?

    Hey, I was just about to flash my kt-lcd3 to use with my 52v tsdz2 and once I opened the lcd3 I noticed a green wire just loose in the back... Anyone know what's up with that? Where is it supposed to be soldered, I figure it's a line of wires so in my mind it's supposed to be where there is no...
  9. Zeggi

    TSDZ2 mid drive with 860C, 850C or SW102 displays only -- Flexible OpenSource firmware (Casainho code only)

    Deleted
Back
Top