Search results

Date Relevance Most replies

  1. B

    Microprocessor controlled throttle thru KLS96601-8080H

    good advice, thankyou
  2. B

    Not Another Electric Enduro Bike

    Hi How do you go getting CAN data from the Kelly? Would like to do the same
  3. B

    Votol EM-200 Controller

    torque increases with the airgap diameter squared, it's also proportional to pole count so it increases even further on the hub motor (205/138)^2=2,21 Power= torque*rpm/9.55 either it's torque or speed that creates the power, you choose. Is there a setting for Torque or Speed mode?
  4. B

    Kelly Controllers Configuration Program - a Definitive Translation

    I have a KLS96601 8080H Anybody know how to change its Control mode between Speed, Torque and Balanced? Control mode does not show on the GUI
  5. B

    Kelly KLS-8080H QS WP8000

    We have a KLS96601 8080H - Serial 1903-19005478 working on a QS WP8000 The motor increases speed when the TPS control voltage is not changing and/or decreasing We can demonstrate the problem on this video showing motor speed and voltage...
  6. B

    Microprocessor controlled throttle thru KLS96601-8080H

    Thanks for the guidance Have now taken this a little further We are using a ESP32 to generate a DAC signal of between 1-3.6V This is sent to the Kelly Controller which has a TPS input choice of 0-5v or 1-4.5v Our signal works on either setting The degree of throttle control is good barring one...
  7. B

    Looking for Info. on Cyclone 480 watt motor with Kelly cont

    Hi We would like to control the speed of our hub motor using a micro processor, an arduino or an ESP32 We are using a kelly KLS96601 8080H. Did you hook the the arduino to your the Kelly controller. How did it work out, any feedback? I hooked up my Arduino Uno and and drove the motor command...
  8. B

    Microprocessor controlled throttle thru KLS96601-8080H

    Looking for help on driving a hub motor via a Kelly KLS96601-8080H controller using a micro processor like an Arduino or an ESP32 Perhaps emulating the throttle pot input using 0-5v? Has anybosy already done this, would appreciate some guidance
Back
Top