Hello,
I just assembled my first DIY ebike, took it for a ride, and everything was great until the 3 phase hub motor spun out of the bike's dropouts. Now the bike is dead.
All the wires running into the motor look OK. None of them are torn from what I can see. ( I also tested the phase wires. This ebike doesn't need hall wires to be connected, so I didn't test them).
Unfortunately when I tested the hall wires (black and red) running out of the controller, a reading of 0V was returned. Strange..but then this bike doesn't need hall wires anyway.
My LCD3 display shows that the battery is totally drained, even though it's fully charged..
Any help is much appreciated!
Cheers
I just assembled my first DIY ebike, took it for a ride, and everything was great until the 3 phase hub motor spun out of the bike's dropouts. Now the bike is dead.
All the wires running into the motor look OK. None of them are torn from what I can see. ( I also tested the phase wires. This ebike doesn't need hall wires to be connected, so I didn't test them).
Unfortunately when I tested the hall wires (black and red) running out of the controller, a reading of 0V was returned. Strange..but then this bike doesn't need hall wires anyway.
My LCD3 display shows that the battery is totally drained, even though it's fully charged..
Any help is much appreciated!
Cheers