BlitzKrieg
10 mW
- Joined
- May 16, 2018
- Messages
- 24
Hello guys.
I have bought used goped esr750 hoverboard with dead LiPo batteries. They are almost dead. I have no money and purpose to buy new LiPo batteries because the weather in my country does not let me use goped often. So i need an easy care batteries. I will use iCharger 106B+ to charge it and don't need an on-board charger at all. Is it possible to use hoverboard controller with SLA batteries without any changing and programming? It is expensive to buy new controller for SLA batteries too. Especially that i don't really know will i use hoverboard or not. I would like to try it with minimal costs.
And the second question. How can i check if on-board charger is working properly. I try it output with volt tester but it shows only 0.
Maybe i should to connect two of four wires together to start it like computers power supply?
Thanks a lot.
I have bought used goped esr750 hoverboard with dead LiPo batteries. They are almost dead. I have no money and purpose to buy new LiPo batteries because the weather in my country does not let me use goped often. So i need an easy care batteries. I will use iCharger 106B+ to charge it and don't need an on-board charger at all. Is it possible to use hoverboard controller with SLA batteries without any changing and programming? It is expensive to buy new controller for SLA batteries too. Especially that i don't really know will i use hoverboard or not. I would like to try it with minimal costs.
And the second question. How can i check if on-board charger is working properly. I try it output with volt tester but it shows only 0.
Maybe i should to connect two of four wires together to start it like computers power supply?
Thanks a lot.