johnrobholmes
10 MW
My one year goal is to produce more of my products in house, and I am currently gearing up for brushed motor armature production. Since the toy and small scale side of my business is by far the largest chunk of my daily bread, (and economies of scale are easier) I am starting with some small brushed motors that people are hankering for. Many studies on industrial motor design have paid off, and I found a nice winding scheme that isn't too crazy and also allows me to pack in 30% more than I can get from the china handwinders.
Two 10lb spools of wire with 200c coating, almost $400. Wish me luck so that I can fit a few more turns in these puppies! Once these motor lines take off I will start researching what it takes to get some stators EDM cut for bigger motors. If I can't buy what I want, might as well make it. These arms will get my winding callouses ready!
Parden the messy solder, I should have used a cooler iron or the proper brazing filler.
Two 10lb spools of wire with 200c coating, almost $400. Wish me luck so that I can fit a few more turns in these puppies! Once these motor lines take off I will start researching what it takes to get some stators EDM cut for bigger motors. If I can't buy what I want, might as well make it. These arms will get my winding callouses ready!
Parden the messy solder, I should have used a cooler iron or the proper brazing filler.