So I bought a Kelly 8080IPS with sine cosine input. I am trying to use it on the motor in the picture. The motor has a resolver in it. I was told resolver and sine cosine were the same thing, but now I'm being told other wise.
And here is the wiring diagram...
The resistance on the 3 coils is 29 ohm, 29 ohm, 16 ohm.
I was thinking I could take a leg from each coil and connect to ground. Then take the 5V and attach to a leg on the 16 ohm, and take the 2 other legs from the 29 ohm, and 29 ohm and connect that to sine cosine...
Does that work? Any help is appreciated.
Thank you
Eric Ensley
And here is the wiring diagram...
The resistance on the 3 coils is 29 ohm, 29 ohm, 16 ohm.
I was thinking I could take a leg from each coil and connect to ground. Then take the 5V and attach to a leg on the 16 ohm, and take the 2 other legs from the 29 ohm, and 29 ohm and connect that to sine cosine...
Does that work? Any help is appreciated.
Thank you
Eric Ensley