Harllequin
1 mW
- Joined
- Feb 14, 2020
- Messages
- 11
Good afternoon chaps.
After a good while of enjoying the bike I built for commuting what you guys helped me spec years ago I've run into a problem.
The throttle works fine but when I pedal it does not activate the hub motor any more.
My particular version of the S861 has the following menu :-
p01 Wheel size
p02 Magnet count
p03 Display backlight
p04 Miles or KM
p05 Voltage
p06 Off timer
p07 Max speed limit
p08 (not sure
p09 odometer reading / reset
Nothing in the setting has been change since the fault came about and I can't see anything in that menu that would prevent the PAS from activating.
Got out the multi-meter, my guess is: -
Black = ground
Red= supply
Green = signal
My red is showing 5.1v
The green is constantly showing 4.6v no mater if the crank is turning or not.
I've got no error messages on the screen.
Any advice on trouble shooting would be most welcome please.
Thank you kindly in advance.
After a good while of enjoying the bike I built for commuting what you guys helped me spec years ago I've run into a problem.
The throttle works fine but when I pedal it does not activate the hub motor any more.
My particular version of the S861 has the following menu :-
p01 Wheel size
p02 Magnet count
p03 Display backlight
p04 Miles or KM
p05 Voltage
p06 Off timer
p07 Max speed limit
p08 (not sure
p09 odometer reading / reset
Nothing in the setting has been change since the fault came about and I can't see anything in that menu that would prevent the PAS from activating.
Got out the multi-meter, my guess is: -
Black = ground
Red= supply
Green = signal
My red is showing 5.1v
The green is constantly showing 4.6v no mater if the crank is turning or not.
I've got no error messages on the screen.
Any advice on trouble shooting would be most welcome please.
Thank you kindly in advance.