Simply removed controller to see about potential shunt mod, after putting it back together it wouldn't work.

[9lives304]

So now I have found another controller that I already had I've got a lot that literally tell me no wattage no voltage no maker or developer absolutely nothing well I of course have designated the three phase speed wires as well as the hall sensor wires the power and negative that goes to the battery but then I am stuck I am going to post the picture that I took that I wrote down on a pad trying to find out what these things were as I'm trying to learn what the letters on the bottom of the PCB are and what corresponding function they go to so without a further ado here's what I've got.......



Any and all help in relation to this would be greatly appreciated. The controller that was on it literally had the 9 pin hookup to the hub motor as well as a Joliet connector and a pas connector.....this new(OLD) controller has none of these.