dgbat2
1 mW
- Joined
- Feb 10, 2017
- Messages
- 13
I ordered a tongsheng kit, installed and all's good, next I want to add lights.
I received one of these with the kit:
What is the pinout for this Y splitter? One of the pins must be the 6V lighting connection.
I consider getting a 'speed sensor extension cable' to run the cable and have a waterproof connection. I might have to get a multimeter out, problem being of course the connector is so small there is a risk of shorting or overloading something.. actually I can have the GND of the meter connected to the BATT GND somewhere else, and then just test one pin at a time, turning the light setting on and off from the display and looking for the expected value, that'd be safe.
Cheers in advance.
Dan
I received one of these with the kit:
What is the pinout for this Y splitter? One of the pins must be the 6V lighting connection.
I consider getting a 'speed sensor extension cable' to run the cable and have a waterproof connection. I might have to get a multimeter out, problem being of course the connector is so small there is a risk of shorting or overloading something.. actually I can have the GND of the meter connected to the BATT GND somewhere else, and then just test one pin at a time, turning the light setting on and off from the display and looking for the expected value, that'd be safe.
Cheers in advance.
Dan