Recent content by CdnE90

Thanks mushymelon! Although it was a different board, the wiring is the same. I soldered on some new leads and bench tested the speedo sensor. Everything seems to be working properly. Now, to address the issue that caused the broken wires - the movement of the motor in the bottom bracket...

So... update. I checked continuity between the plug and the wheel sensor. Nothing. So, at this point, it's either the wire has a break in it, or the wire is disconnected from the controller card. I cut the wire a couple of inches from the main motor body (what do I have to lose?) and checked...

Does anyone know if the Filzer uses a reed sensor? (http://www.mec.ca/product/5005-085/filzer-db-wiring-kit/)

Charlie, Going to have to try and switch to a reed type because it sounds like I'm having the same issues as you (see http://endless-sphere.com/forums/viewtopic.php?p=986624#p986624). I just don't have an old reed type speedo laying around, so I might have to go down to my LBS to see if they...

Which is the pas sensor plug?

I'm getting the Err 21 on my display (BBS02, 750W), which is according to the manual, is a "speed sensor abnormality". The motor still works, just doesn't show speed and can't change the PAS setting once on the move. This was becoming annoying, so I do the following to remedy: 1. Check to...

How's the nexus holding up? I ride my bike as a daily commuter, and with the winter coming, I'd like to switch. I'm worried about durability.

I'm in.

Found them with a Google search. I was looking for an ebike battery case, and discovered they sell the BBS0x line. I used Paypal. They were quite responsive by email. Usually within an hour I would have a response. I asked them about programming and shipping methods -- they don't reprogram...

I had a great experience with TNA Battery: http://www.tnabattery-ebike.com/ Got it delivered in less than 2 weeks, shipping cost of about $90 to Canada.

I'm looking to add a half or full twist throttle. Can anyone tell me if there is an available twist throttle that has the same connector? Otherwise, is the throttle wire on the BBS a three wire?

Somebodybuythisguyabeer. :D Seriously. +1. Bravo.

The thumb throttle I got with my kit can be used on either the left or right side (Mar 14 production serial #). There is a groove on both sides of the clamp for the wire to reside in depending on what side it is mounted.

Thanks for the reassurance. It was a tight fit to get the drive unit into the BB, so I was afraid that I hadn't got it quite seated far enough, even though I thought it was in all the way. I didn't want to resort to the BFH to persuade it further into the BB. Everything else with the kit...

I'm installing a BBS02 for the first time, and have run into a snag (see photo). There seems to be a gap between the fixing plate and the motor unit after being (seemingly) fully inserted into the BB. This is on a Norco Storm with 68 mm BB. Is this normal?