Not sure if I should start my own post or hijack this one(?)
Seems most inline skate discussions happen here.
I am done drafting my "small-scale" 2 way clutch, Inventor is telling me it will fail at ~3Nm, which is bad...
A few short calculations imply that torque needed is 7.5 ~ 15Nm. Probably more.
The only way is to scale up, I can get 40Nm if I go up to 80mm, but the clutch will be the size of a small wheel
Maybe it would be best to have a conventional clutch that engages when driving and automatically disengages when motor is off.
Although I'm tempted to fabricate it just for a proof of concept, waiting on quote from my fabricator.
I see many inline skating youtubers talking about the thundrblades recently, but the crowdfunding still seems stagnant.