danielnilsson9
1 W
- Joined
- Jan 5, 2021
- Messages
- 61
Yes, I'm currently working on the configuration tool to go along with this firmware, a few small things left to do there.
As for the firmware itself there are some minor thing left to do there too but the important stuff is working.
Still need to do:
* Speed limiting according to configuraiton
* Temperature limiting
* Send error codes along to the display
* Turn on/off lights
* Documentation
But the important stuff is working, throttle, pas, communication with the original bafang display etc.
I'm aiming for a public release at the end of the month if nothing else comes up.
There will be two binary files, one for controller revision 1.4 and one for 1.5 since the MCU and the EEPROM layout differs the same binary cannot be used.
I would not recommend building and flashing the firmware at the moment as the status is unknwon at times and config tool not yet useful, especially not if you have controller revision 1.4 since there is no way of going back to the original firmware.
As for the firmware itself there are some minor thing left to do there too but the important stuff is working.
Still need to do:
* Speed limiting according to configuraiton
* Temperature limiting
* Send error codes along to the display
* Turn on/off lights
* Documentation
But the important stuff is working, throttle, pas, communication with the original bafang display etc.
I'm aiming for a public release at the end of the month if nothing else comes up.
There will be two binary files, one for controller revision 1.4 and one for 1.5 since the MCU and the EEPROM layout differs the same binary cannot be used.
I would not recommend building and flashing the firmware at the moment as the status is unknwon at times and config tool not yet useful, especially not if you have controller revision 1.4 since there is no way of going back to the original firmware.