Pinesal
100 W
It's a 48v, 600 watt motor. the bike is a X-treme xb-610 (http://www.x-tremescooters.com/electric_bicycles/xb610/xb610.html), I know it's not the typical form of a bicycle but it uses the same kinds of parts. The NEW controller is 48v 1000 watts. I have no information about the old controller other than that it was the stock controller that came with the bike and some info about it is on the diagram.
I bought this one on ebay http://www.ebay.com/itm/271745932184
It's not an exact match but I thought I could make it work. There are a few things I took an educated guess about but it doesn't seem to be working. I have a wire diagram of my bike below.
The first problem is the throttle. My bike has four wires going to the throttle but the new controller has 3. I have looked this up and the fourth wire is usually for a power indicator, but my bike never had a power indicator, so I don't know what it's for or which three I am REALLY supposed to hook up and the colors also don't match up so that is throwing me off. I have a Green Black and Red on the controller and I have Pink Gray and Green (shown as black in the diagram?)
The other problem is the HALL sensor cables vs the LCD cable, they are both five cable with the exact same coloration. One of the connecters perfecty fits the hall sensor connector for the bike so I assumed that was it but I have no other reason to believe so.
The last think is the power, the new controller has a thick black and and a thick red cable but on the bike side, the there is another smaller white cable that accompanies the thick red one the original controller had a small orange cable the connected to the white cable. The diagram shows that it's part of the on/off switch. This may in fact be my problem but I wouldn't know where to hook up this white wire because the new controller doesn't have a equivalent.
If it makes any difference, when I did switch the bike ON the battery indicator showed a FULL battery.
I bought this one on ebay http://www.ebay.com/itm/271745932184
It's not an exact match but I thought I could make it work. There are a few things I took an educated guess about but it doesn't seem to be working. I have a wire diagram of my bike below.
The first problem is the throttle. My bike has four wires going to the throttle but the new controller has 3. I have looked this up and the fourth wire is usually for a power indicator, but my bike never had a power indicator, so I don't know what it's for or which three I am REALLY supposed to hook up and the colors also don't match up so that is throwing me off. I have a Green Black and Red on the controller and I have Pink Gray and Green (shown as black in the diagram?)
The other problem is the HALL sensor cables vs the LCD cable, they are both five cable with the exact same coloration. One of the connecters perfecty fits the hall sensor connector for the bike so I assumed that was it but I have no other reason to believe so.
The last think is the power, the new controller has a thick black and and a thick red cable but on the bike side, the there is another smaller white cable that accompanies the thick red one the original controller had a small orange cable the connected to the white cable. The diagram shows that it's part of the on/off switch. This may in fact be my problem but I wouldn't know where to hook up this white wire because the new controller doesn't have a equivalent.
If it makes any difference, when I did switch the bike ON the battery indicator showed a FULL battery.