Little-Acorn
100 W
- Joined
- Oct 15, 2009
- Messages
- 130
Does anyone knnow where to get the connectors that are commonly found on the ribbon cables for e-bike batteries and chargers?
Not the heavier 14ga or 12ga wires that carry the main drive current from the batteries. I'm talking about the ribbon cables that are used for cell balancing by the charger. I'd like to make some custom cables for the battery charger, and I'm hoping to match the existing connectors.
Anyone know where to find those connectors? So I can solder or squeeze them onto the correct-size ribbon cable, and either make a new cable, ir an extension cord for an existing cable?
I have a 48V 1000W system, with sixteen cells, so I'd need a connector that goes in 16-wire ribbon cable. I'd like to find both male and female connectors.
Not the heavier 14ga or 12ga wires that carry the main drive current from the batteries. I'm talking about the ribbon cables that are used for cell balancing by the charger. I'd like to make some custom cables for the battery charger, and I'm hoping to match the existing connectors.
Anyone know where to find those connectors? So I can solder or squeeze them onto the correct-size ribbon cable, and either make a new cable, ir an extension cord for an existing cable?
I have a 48V 1000W system, with sixteen cells, so I'd need a connector that goes in 16-wire ribbon cable. I'd like to find both male and female connectors.