Nogwin
10 mW
Just bought a spare analogue 24-72v Xlyte controller, and found it has the 4 wire throttle cable. My old 1/2 twist throttle is 3-wire, and I tried all the 8 combos and the motor still does not move (I know about the 4th - which is batter +v). Checked the multimeter on the signal from green hall wire and it read ~4.5V, but it did not change. Same throttle on the infineon controller works great 0.5-5V.
So is it a case where this throttle will never work on the Xlyte, or do I have to have the hall wires and phase wires hooked up to the motor so it will work?
I do know the 4th wire has the battery voltage (in this case 48v), and can measure it fine, but twisting the throttle using any combo of R/G/Y shows no voltage change!
(Like I mentioned before, this throttle works on the infineon controller as I just checked)...
Not sure what to do next..
Nog
*edit*
Is it possible that one has to rewire for a 3 wire throttle on the controller board?
So is it a case where this throttle will never work on the Xlyte, or do I have to have the hall wires and phase wires hooked up to the motor so it will work?
I do know the 4th wire has the battery voltage (in this case 48v), and can measure it fine, but twisting the throttle using any combo of R/G/Y shows no voltage change!
(Like I mentioned before, this throttle works on the infineon controller as I just checked)...
Not sure what to do next..
Nog
*edit*
Is it possible that one has to rewire for a 3 wire throttle on the controller board?