saiyan
100 W
Hey guys,
I know there have been a few topics regarding what i am trying to do but after hours of searching i still have a few questions im still unsure of before i go ahead with my project.
basically i would like to run 2 hp power supplys in series to double the voltage for my rc charger. ill post up links on exactly what i want if it helps.
http://www.ebay.com.au/itm/171386176239?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT this is what i am going to buy.
https://www.youtube.com/watch?v=aVbk7cpOJuE this is what i would like to do.
ok so my question are,
1 - in the video with the guy removing the ground to 1 of the case, would it be better for me to do it to both of the supplys? the reason i ask is sometime in the future i will be connection 4 power supply to make about 48v for bigger rc charger.
at the moment i will only be running 2 but i have no problem spending abit of time making sure it is more safer for me to use.
2 - in the video i notice the guy had both power supplys plugged in to the power outlet. is it possible to simply cut and wire up the power chord in parallel to make just 1 power chord? do you need to modify anything if you do that?
3 - is it possible to slighty change the voltage in the power supplys as my current rc charger shows on the back it takes voltage between 13v-18v.
any other information regarding my project would much be appreciated guys.
bruce
I know there have been a few topics regarding what i am trying to do but after hours of searching i still have a few questions im still unsure of before i go ahead with my project.
basically i would like to run 2 hp power supplys in series to double the voltage for my rc charger. ill post up links on exactly what i want if it helps.
http://www.ebay.com.au/itm/171386176239?_trksid=p2055119.m1438.l2649&ssPageName=STRK%3AMEBIDX%3AIT this is what i am going to buy.
https://www.youtube.com/watch?v=aVbk7cpOJuE this is what i would like to do.
ok so my question are,
1 - in the video with the guy removing the ground to 1 of the case, would it be better for me to do it to both of the supplys? the reason i ask is sometime in the future i will be connection 4 power supply to make about 48v for bigger rc charger.
at the moment i will only be running 2 but i have no problem spending abit of time making sure it is more safer for me to use.
2 - in the video i notice the guy had both power supplys plugged in to the power outlet. is it possible to simply cut and wire up the power chord in parallel to make just 1 power chord? do you need to modify anything if you do that?
3 - is it possible to slighty change the voltage in the power supplys as my current rc charger shows on the back it takes voltage between 13v-18v.
any other information regarding my project would much be appreciated guys.
bruce