So, I burned out the FETs on my stock BBSHD controller. Taking it apart, I decided it's a bad design (the FETs don't get much heat transfer to the heat sink because of the insulators between the sink and the drains) and I will likely just burn a new one up again. And I wouldn't mind getting some more power.
I looked around and found some good articles in the forum about using external controllers with the BBSHD. This post has good info on how to wire up a Cyclone controller. I thought it looked easy enough so I ordered the stock Cyclone controller, except I decided to get the small "tiny" controller.
Anyone have any info on it? Is it at all programmable? If it doesn't work out then I'll probably get the Baserunner_L10. I have the Hailong battery caddy after all. I just didn't find out about the Grin controllers until after I had ordered the Luna controller (this is my first foray into e-bikes). Anyway, for $75 it's not a terribly expensive experiment.
First post here, and this forum has been really helpful so far. Thanks, all!
I looked around and found some good articles in the forum about using external controllers with the BBSHD. This post has good info on how to wire up a Cyclone controller. I thought it looked easy enough so I ordered the stock Cyclone controller, except I decided to get the small "tiny" controller.
Anyone have any info on it? Is it at all programmable? If it doesn't work out then I'll probably get the Baserunner_L10. I have the Hailong battery caddy after all. I just didn't find out about the Grin controllers until after I had ordered the Luna controller (this is my first foray into e-bikes). Anyway, for $75 it's not a terribly expensive experiment.
First post here, and this forum has been really helpful so far. Thanks, all!