boerhunter
1 µW
Hi,
Firstly I'm extremely grateful in advance for any advice.
My issue is a 72v 8000w stealth clone with a 150a sabvoton controller with Bluetooth. It worked fantastically, but I became severely ill and couldn't ride for 18 months (nearly died, so grateful to be here).
Now it turns on, charges, starts to run but if I accelerate it cuts out, flashing the motor/communication error (30h). To turn it back on it needs to be on charge then it will start.
I connected to it via blootooth via the mqcon app and it has good battery, hall tests fine etc. When raised I can gently rev up the engine and it will turn over quite fast but will cut out at full throttle. When I'm on it I can ride circa 7mph, then it cuts out after 30 seconds or if I accelerate.
So it's cutting out when the motor is under load.
All cables seem to be in good order, it was working perfectly before, battery shows good on phone and display, I've replaced the fuse for good measure but it looked fine. I don't know what the issue is as I'm new to this.
Once again, I'm sincerely grateful for any help
Firstly I'm extremely grateful in advance for any advice.
My issue is a 72v 8000w stealth clone with a 150a sabvoton controller with Bluetooth. It worked fantastically, but I became severely ill and couldn't ride for 18 months (nearly died, so grateful to be here).
Now it turns on, charges, starts to run but if I accelerate it cuts out, flashing the motor/communication error (30h). To turn it back on it needs to be on charge then it will start.
I connected to it via blootooth via the mqcon app and it has good battery, hall tests fine etc. When raised I can gently rev up the engine and it will turn over quite fast but will cut out at full throttle. When I'm on it I can ride circa 7mph, then it cuts out after 30 seconds or if I accelerate.
So it's cutting out when the motor is under load.
All cables seem to be in good order, it was working perfectly before, battery shows good on phone and display, I've replaced the fuse for good measure but it looked fine. I don't know what the issue is as I'm new to this.
Once again, I'm sincerely grateful for any help