Enkidu
10 mW
Recently I bought a "kit" from Grin and added them to my Bike Friday New World Tourist. Rode it a few times and loved it. Last week I went to go for a ride and the motor stopped after about 5 seconds. Restarted the the Baserunner and tried riding again and the motor cut off again. So I restarted the Baserunner again and held the front wheel off the ground and the motor ran like normal and did not stop Then I set the bike on the ground and tried riding and it stopped again after 5 seconds.
This is very weird. Why would the motor stop when I am on the bike but run freely when I hold the wheel off the ground? I have not made any SW changes to the Baserunner or the V3 Cycle Analyst.
Here is what I installed on the bike;
Shengyi DGWX1 SX1 Helical Geared Hub Motor, Fast Wind
V4 Baserunner Z9
V3.1 Cycle Analyst
B3620Li-DT battery
PAS 24P
Any thoughts as to what is going wrong with it? I can upload the Baserunner and CA files if need be.
Thank You
Zack S
This is very weird. Why would the motor stop when I am on the bike but run freely when I hold the wheel off the ground? I have not made any SW changes to the Baserunner or the V3 Cycle Analyst.
Here is what I installed on the bike;
Shengyi DGWX1 SX1 Helical Geared Hub Motor, Fast Wind
V4 Baserunner Z9
V3.1 Cycle Analyst
B3620Li-DT battery
PAS 24P
Any thoughts as to what is going wrong with it? I can upload the Baserunner and CA files if need be.
Thank You
Zack S